When you crank the bike, only let it crank for a second or two. This might cause the electronics on the bike to burn up. Finally, when the motorcycle starts up, go ahead and disconnect the cables. Using a car battery might cause the starting electronics to engage more quickly than they normally do. Just remember that as soon as the bike starts up, take off the cables and let it sit and idle or go for a ride in close quarters for about 20 min to make sure that the charge is good.
After all of this is said and done, make sure you can take your motorcycle somewhere to get checked out. Because the batteries on motorcycles are smaller than cars, they can become very worn after being fully discharged. Checking the battery is very simple, and should only take about 20 minutes. Will this make sure your motorcycle starts up and gets to where it needs to be going?
Yes, it will get you there, so that makes it good, but do you risk a lot doing it? Yes, you do. Leave the motorcycle running until you drive it home or to a bike shop to get a new battery or a proper recharge.
He writes about business, personal finance and careers. Adkins holds master's degrees in history and sociology from Georgia State University. He became a member of the Society of Professional Journalists in Step 1 Turn off both vehicles and make sure lights and other equipment is also turned off. Step 2 Connect one red clamp to the positive terminal of the motorcycle battery.
Step 3 Connect the other red clamp to the positive terminal of the car battery, making sure the clamp touches nothing else. While both a car and your bike have batteries and electrical systems, the two are NOT equal. Instead of needing a simple jump, you could end up with much deeper, more serious headaches to worry about. You can avoid all this by simply keeping the car in this equation turned off for the duration of the jump start procedure. Double-check that everything is clamped correctly to avoid any issues.
You may need to fiddle around a little to make everything connect the way it needs to do in order to successfully jump your bike.
Do NOT turn on the car. Yes, it can be dangerous to jumpstart motorcycles with car batteries, and even manufacturers discourage it. It is dangerous to jumpstart a motor vehicle, including a motorcycle, with electrical cables. The reason is that invariable final connections cause a spark, and it may result in an explosion and not just flames. Besides, a lead-acid battery in typical internal combustion vehicles produces hydrogen gas during the work cycle.
Not being careful can result in burns, and it is worse when the spark is closer to fuel or hydrogen gas. Yes, you can jumpstart a motorcycle with a car battery. A typical car battery has a higher amperage than a motorcycle battery, making it possible to jumpstart your motorcycle using a car battery. However, you must not make it a habit to jumpstart your motorbike using a car battery always; it must be during emergencies only. Note that this practice can damage or degrade your motorcycle components and void the warranty on the battery.
Regardless of the dangers, you can jumpstart your bike safely with a car battery. What you require is a jumper cable to jumpstart the motorcycle with your car. First, turn off the ignitions on the car and motorcycle. It is important to disable ignitions on both motor vehicles to prevent ruining the voltage regulator or motorcycle battery. Next, connect one of the red jumper cable clamps to the positive terminal of the battery of your motorcycle.
The red jumper cable clamps must be connected to the red positive terminal on the motorcycle battery. Note that positive goes to positive. On the car battery, connect the near the car to the negative post. Note that the negative posts in most new cars sit several inches away from the battery.
0コメント